Sony DCR-TRV820 - Manual (Page 113)

113
Printing operations
Making prints – Standard print
To cancel printing
The print paper is automatically ejected by setting the POWER switch to OFF
(CHARGE) once and then to MEMORY. To resume printing, insert new print paper and
repeat the procedure from step 4.
Notes
•During printing, the print paper is inserted and ejected between the paper dispenser
and the printer cover.
Do not place any objects that may prevent the print paper from being inserted and
ejected from the body.
•During printing, do not draw out the print paper. Doing so might cause your
camcorder to malfunction.
•During printing, do not touch the print surface.
•During printing, do not subject the body to vibration or shock.
•Printing is canceled midway if the LCD panel or printer cover is closed during
printing. If you open the LCD panel or printer cover again, the print paper will
automatically be ejected. You cannot continue the printing.
•Repeat prints cannot be made of the same screen.
We recommend making repeat prints from images stored on “Memory Stick.”
•Printing images recorded continuously, multi screen, is not possible. To print those
images, store them on “Memory Stick” in advance.
•The quality of printed images sometimes deteriorates considerably or printing is not
performed if prints are made at a high temperature exceeding the guaranteed
operating temperature range.
•The possible number of prints is sometimes considerably reduced if prints are made at
a low temperature exceeding the guaranteed operating temperature range.
•The color of printed images sometimes changes slightly depending on the ambient
temperature conditions during printing.
After printing started
While the ribbon is being aligned, print paper is sometimes inserted and ejected from
the left and right sides of the body without the LCD screen turning off even if PRINT
lamp flashes slowly.
To make a print
It takes about 150 seconds.