Sony VGN-S380P - Manual (Page 107)

Connecting the Port Replicator
When using the port replicator, always use the AC adapter to power the port replicator; otherwise, the port
replicator will be without power and will not function properly. Also, take precautions to avoid disconnecting the AC
power supply when moving the computer with the port replicator attached.
Before you connect the port replicator, you may want to install the rechargeable battery, if it is not already installed. The
installed battery automatically charges while the computer and port replicator are powered by the AC adapter.
Connecting a port replicator while the computer is in a power saving mode (Standby or Hibernate) may result in data
loss or a computer malfunction.
To connect a port replicator
1. Close active programs to prevent data loss.
2. Turn off the computer, and disconnect all attached devices.
3. Plug the power cord into the AC adapter and an AC outlet.
Make sure to use the supplied AC adapter.
4. Plug the cable attached to the AC adapter into the DC IN port on the port replicator.
5. Place the port replicator on a stable surface, and pull out the extendable support arm, which is located on the
front edge of the port replicator.
Pulling Out the Extendable Support Arm
6. On the bottom of the computer, slide the port replicator cover down until the port replicator connector is
completely visible.
Sliding the Port Replicator Cov er*
* T he bottom panel illus tration may vary s lightly from the ac tual c omputer.
7. Slip the back edges of the computer into the raised edges on the port replicator.
Connecting the Port Replicator
Page 107