Sony SDM-M61 - Manual (Page 7)

7
GB
G:\_Upload\4084256121\4084256121SDMM61AEP\02GB-SDMM61AEP\01GB02BAS-UC.fm masterpage:Right
SDM-M61
4-084-256-12(1)
Setup
Before using your monitor, check that the following items are
included in your carton:
• LCD display
• Power cord
• AC adapter
• DVI-HD15 (analog RGB) video signal cable
• Audio cord (stereo miniplug)
• Cord strap
• Windows Monitor Information/Windows Utility/Macintosh
Utility Disk
• Warranty card
• This instruction manual
Step 1: Connect the display to your
computer
Turn off the monitor and computer before connecting.
If you connect the monitor to a computer equipped with a DVI
(digital RGB) output connector that complies with DVI Rev. 1.0,
use a DVI-DVI (digital RGB) video signal cable (not supplied).
Note
Do not touch the pins of the video signal cable connector as this might
bend the pins.
x Connecting to an IBM PC/AT or compatible
computer
x Connecting to a Macintosh
If necessary, use a Macintosh adapter (not supplied).
Step 2: Check the digital/analog
select switch
Before turning on the monitor, be sure to check the switch setting.
When connecting the DVI-I input connector on the monitor to a
computer equipped with an HD15 (analog RGB) output connector
using the DVI-HD15 (analog RGB) video signal cable (supplied),
set the switch to A – the right position.
When connecting it to a computer equipped with a DVI (digital
RGB) output connector using a DVI-DVI (digital RGB) video
signal cable (not supplied), set the switch to D – the left position.
The switch is set to the right position (for analog RGB signal
input) as the default setting.
IBM PC/AT or
compatible computer DVI-HD15 (analog RGB) video
signal cable (supplied)
to video output
Macintosh adapter
(not supplied)
DVI-HD15 (analog RGB)
video signal cable
(supplied)
to video output
Macintosh
D A
(continued)
01GB02BAS-UC.book Page 7 Monday, July 2, 2001 2:26 PM