Sony DCR-IP7BT - Manual (Page 22)

22
Notes
• The "Scan" button cannot be clicked after all thumbnail images have been
imported.
• If the length of images recorded on a videotape is extremely short, thumbnail
images may not be imported even when you click the "Scan" button.
• If the information of the images recorded on a videotape differ from the
information of the images displayed on the Index tray, turn off the power of the
MICROMV device and turn it on again.
5
Select the thumbnail image to be captured, and then click the
"Batch Capture" button.
The confirmation dialog (dialogue) box appears.
z Hint
To select more than one thumbnail image simultaneously, click on the desired
thumbnail images while pressing the Ctrl key. To select a sequential block of
thumbnail images, click on the first thumbnail image, and then click on the last
thumbnail image while pressing the Shift key.
Note
When you capture images by clicking the "Batch Capture" button, images are not
displayed on the monitor while capturing.
6
Click "OK."
The confirmation dialog (dialogue) box closes, and the dialog (dialogue)
box indicating capturing progress appears.
z Hint
You can cancel capturing by clicking the "Stop" button while capturing.
When capturing is finished, the dialog (dialogue) box indicating
importing progress appears.
When importing all images is finished, the captured files are placed on
the Clip tray.
Note
A thumbnail image that appears on the Index tray may not be the exact frame at the
recording start point (but close to it). This is because the thumbnail image is imported
while the videotape is scanned at high speed.
A thumbnail image that appears on the Clip tray is always the exact first frame of the
captured file. Therefore, if you capture fast moving images, there may be a big
difference between the thumbnail images on the Clip tray and those on the Index tray.