Sony LF-X1 - Manual (Page 11)

11 Step 3 Setting Up the NetAV Function
Pr
ep
arat
io
ns
P
rio
r to
A
c
c
ess
fr
om a
Re
mot
e
L
oca
tio
n
Pre-release version
(2) Clear the [Automatic IP address configuration (DHCP)] check box.
The information in the fields will clear, which releases the “automatic”
IP settings.
(3) Enter again the information you jot down in step (1) - with one exception:
For the IP address, be sure to change the last two digits to 64*.
* If you entered a different IP address for the port forwarding or DMZ settings of your
router, make the last two digits match that address.
(4) Click [Set] to lock in the IP address and other important information on
this screen.
z Tip
Jot down the IP address that you specify. You will need it to establish a
connection to the base station from your computer.
3
Connect to the Internet to confirm that LAN settings are correct. Go to the
Web function. If the web page appears, your settings are correct. If the web
page does not appear, you may not have entered the information correctly in
Step 2. Go back and confirm that information has been entered correctly.
4
Configure the base station NetAV.
Select [Settings], [Base station], [NetAV Settings], and then [Enable/Disable
NetAV].
To send video from the base station to a remote computer in the [Enable/
Disable NetAV] screen as described below.
Select [Enable]
Specify a port number
(5021 is commonly used)