Sony DCR-TRV460 - Manual (Page 15)

Getting started
D:\##SAGYO\DTP-shanhai-agari\824719S DCRTRV360-US\824719S DCR-TRV360_US\824719S DCR-
TRV360_US\3087921111 DCR-TRV360\01GB03PRE.fm
master:Right
Ge
tt
in
g
sta
rte
d
15
DCR-TRV360/TRV361/TRV460
3-087-921-11(1)
6
Slide the POWER switch up to (CHG)
OFF.
The CHG (charge) lamp lights up and
charging starts.
After charging the battery
The CHG (charge) lamp turns off when the
battery is fully charged. Disconnect the AC
Adaptor from the DC IN jack.
To remove the battery pack
1 Set the POWER switch to (CHG) OFF.
2 Lift up the viewfinder.
3 Slide the battery pack out in the direction
of the arrow pressing the BATT (battery)
release button down.
b Note
• If you do not use the battery pack for a long time, use
up the battery pack completely before storing it. See
page 119 about storage of the battery pack.
To check the remaining battery – Battery
Info
You can check the battery’s current charge level
and its current remaining recording time both
during charging or when the power is turned off.
1 Set the POWER switch to (CHG) OFF.
2 Press OPEN and open the LCD panel.
3 Press DSPL/BATT INFO.
The battery information appears for about 7
seconds.
Keep the button pressed to view it for about
20 seconds.
A Battery charge level: Displays
approximate remaining amount of
power left in the battery pack.
B Approximate possible recording time
using the LCD panel.
C Approximate possible recording time
using the viewfinder.
BATT(battery)
release button
POWER switch
POWER switch OPEN
DSPL/BATT INFO
BATTERY INFO
50% 0% 100%
BATTERY CHARGE LEVEL
REC TIME AVAILABLE
LCD SCREEN
VIEWFINDER
:
:
72 min
95 min
, continued