Sony PFM-42V1S - Manual (Page 107)

51
(GB)
Specifications
Specifications
Video processing
Preset signal See page 28 (GB).
Sampling rate 13.5 MHz to 140 MHz
Panel system AC-type Plasma Display Panel
Display resolution 852 dots (horizontal)
× 480 lines
(vertical)
480 dots (horizontal)
× 852 lines
(vertical) (PFM-42V1P)
Pixel pitch 1.08 (horizontal)
× 1.08 (vertical)
mm ( 1 ⁄
32
×
1 ⁄
32
inches)
Picture size 920 (horizontal)
× 518 (vertical)
mm (36 7 ⁄
32
× 20
13 ⁄
32
inches)
518 (horizontal)
× 920 (vertical)
mm (20 13 ⁄
32
× 36
7 ⁄
32
inches)
(PFM-42V1P)
Panel size 42-inch (diagonal 1058 mm)
Inputs and Outputs
INPUT1
RGB/YUV D-sub 15-pin (female) (
×1) (See
“Pin assignment” on page 52
(GB).)
AUDIO Stereo minijack (
×1)
500 mVrms, high impedance
INPUT2 1)
DVI DVI (DVI Specification Rev. 1.0
compliant)
AUDIO Stereo minijack (
×1)
500 mVrms, high impedance
CONTROL S IN/OUT
AUDIO OUT Stereo minijack (
×1)
REMOTE (RS-232C)
D-sub 9-pin (
×1)
VIDEO (NTSC, PAL, SECAM, NTSC4.43,
PAL60, PAL-M, PAL-N)
2)
COMPOSITE IN
BNC (
×1)
Composite video, 1 Vp-p ±2 dB
sync negative, 75 ohms
(automatic termination)
COMPOSITE OUT
BNC (
×1) Loop-through
Y/C IN Mini DIN 4-pin (
×1)
Y (luminance): 1 Vp-p ±2 dB sync
negative, 75 ohms terminated
C (chrominance): Burst
0.286 Vp-p ±2 dB (NTSC),
75 ohms terminated
Burst 0.3 Vp-p ±2 dB (PAL),
75 ohms terminated
AUDIO IN Pinjack (
×2)
500 mVrms, high impedance
SPEAKER 7 W + 7 W (6 ohms), direct
unbalanced impedance:
6-16 ohms
Component/RGB Input Adaptor BKM-V11
(Not supplied)
YUV/RGB IN
YUV/RGB BNC (
×5)
AUDIO Pinjack (
×2)
500 mVrms, high impedance
RGB/Component Active Through Adaptor
BKM-V12 (Not supplied)
RGB/YUV ACTIVE THROUGH
RGB/YUV IN D-sub 15-pin (female) (
×1)
AUDIO IN Stereo minijack (
×1)
500 mVrms, high impedance
RGB/YUV OUT D-sub 15-pin (female) (
×1)
General
Power requirements
100 V to 240 V AC, 50/60 Hz,
3.7 A to 1.5 A
Power consumption
360 W
Operating conditions
Temperature: 0 °C to 35 °C
(32 °F to 95 °F)
Humidity: 20
% to 90%
(no condensation)
Atmospheric pressure: 800 to
1100 hPa
.........................................................................................................................................................................................................
1) The PFM-42V1N is not equipped with the INPUT2 connectors.
2) The PFM-42V1E and 42V1N are not equipped with VIDEO connectors. For these models, composite video and Y/C
input can be input when the Video Input Adaptor BKM-V10 (not supplied) is installed in the display.