Sony PFM-42V1S - Manual (Page 104)

48
(GB)
Power Saving Function
Automatically turns off the power when there is no
input signal to the INPUT1 or INPUT2 connectors
when the input mode is set to RGB.
1
In the Timer/Clock menu, press M/m to move the
cursor (yellow) to “Auto Shutoff” and press
ENTER or
,.
The following menu appears on the screen.
MENU E n d
T i m e r / C l o c k
S l e e p :
C l o c k S e t
C l o c k D i s p l a y :
O n / O f f T i m e r :
A u t o S h u t O f f :
O f f
O f f
O f f
O f f
O n
S e l e c t = S e t
2
Press M/m to select the length of time until the
change to power saving mode.
Off: The power saving function does not work.
On: The power saving function will work.
Note
Input selection is available during power saving
mode.
The ON indicator flashes when the unit is in the
power saving mode.
3
Press ENTER or < to return to the previous
screen.
To cancel the power saving function
Input the signal again, or press the 1 switch on the 1
(standby) switch / indicator section or the POWER
ON switch on the Remote Commander.
Controlling Power On/Off Automatically (Timer Function)