Sony KDL-32XBR4 - Manual (Page 12)

F:\Worker\SONY WAX3 D-series EN 131\3212313131\050GET.fm masterpage:Left
12
KDL-32XBR4/KDL-40D3000
This TV can be installed on a wall by using a Wall-
Mount Bracket (sold separately). Before mounting
the TV on a wall, the Table-Top Stand must be
removed from the TV.
~
• Do not remove the Table-Top Stand for any reason
other than to wall-mount the TV.
Follow the simple steps below to remove the
Table-Top Stand:
1 Disconnect all the cables from the TV.
2 Gently lay the TV, face down, onto a level and
stable surface covered with a thick and soft
cloth. Make sure the Table-Top Stand is
hanging over the edge.
3 Remove the screws as shown in the
illustration for your model and pull the Table-
Top Stand out.
4 Do not remove any other screws from the TV.
~
• Be sure to store the removed screws and Table-Top
Stand in a safe place until you are ready to reattach the
Table-Top Stand. Keep the screws away from small
children.
• For bracket installation, refer to the instruction guide
provided by the Wall-Mount Bracket model for your
TV. Sufficient expertise is required in installing this
TV, especially to determine the strength of the wall for
withstanding the TV’s weight.
• For product protection and safety reasons, Sony
strongly recommends that you use the Wall-Mount
Bracket model designed for your TV and the wall-
mounting of your TV should be performed by a
Sony dealer or licensed contractor.
Preparation for Wall-Mounting
Model: KDL-40D3000
Remove 4 designated screws only.
Level surface
covered with a
soft cloth
Table-Top
Stand
Model: KDL-32XBR4
Remove 3 designated screws only.
Level surface
covered with a
soft cloth
Table-Top
Stand