Setting up lan connection, Setting up isdn connection – Sony PCWA-A500 User Manual

Page 19

Advertising
background image

Setting up LAN connection

Selecting LAN for Connection Mode in

Setting mode-dependent parameters

displays the Setup of LAN Connection Mode dialog box.

Hints

The Access Point acts as a bridge w hen LAN is selected for Connection Mode.

Select this mode w hen connecting the Access Point to a DSL modem if your DSL provider does not use PPPoE for connection. Refer

here

for the

procedure.

1.

Click the IP Se tup tab.

This dialog box is for assigning information such as the IP address of the Access Point.

Static IP Address

Check this option if your ISDN router is not DHCP-compliant or the DHCP is not used, then fill in the follow ing fields.

IP Address
Enter the IP address of the Access Point.

Subnet Mask

Enter the subnet mask of the Access Point.

Default Router

Enter the IP address for the default router.

Hints

Refer to the manual that comes w ith your ISDN router for details.

To save the parameters you have entered the Access Point configuration file on the hard disk, click SAVE CONFIG.
The file may be loaded by clicking LOAD on the "Selection of connection mode and setup of common parameters" dialog box. See

Loading

the Access Point configuration

.

2.

Click NEXT.

A screen appears asking you to confirm the mode you have selected.

3.

Click UPLOAD.

The configuration you have made is registered in the Access Point.

Note

If an error message appears, re-enter the correct data.

Page 19

Advertising