Sony DCR-SR87 - Manual (Page 17)

17
Table of C
on
ten
ts
U
seful R
ec
or
ding
Techniques
Inde
x
Charging time
Approximate time (min.) required when you fully charge a fully discharged battery pack.
DCR-SR47/SR48/SR67
Battery pack Charging time
NP-FH30 (supplied) 115
NP-FH50 135
NP-FH70 170
NP-FH100 390
DCR-SR87
Battery pack Charging time
NP-FH50 (supplied) 135
NP-FH70 170
NP-FH100 390
When the battery pack is charged at 25  C (77 ˚F) (10  C to 30  C (50 ˚F to 86 ˚F) is recommended)
To remove the battery pack
Close the LCD screen. Slide the BATT (battery) release lever  and remove the battery pack
.
To use a wall outlet (wall socket) as a power source
Make the same connections as “Step 1: Charging the battery pack.” Even if the battery pack is
attached, the battery pack is not discharged.
Charging the battery pack abroad
You can charge the battery pack in any countries/regions using the AC Adaptor supplied with
your camcorder within the AC 100 V - 240 V, 50 Hz/60 Hz range.
Do not use an electronic voltage transformer.
Notes on the battery pack
When you remove the battery pack or disconnect the AC Adaptor, close the LCD screen and make sure
that the (Movie) lamp/ (Photo) lamp (p. 19)/ACCESS lamp (p. 16)/access lamp (p. 60) are turned
off.
The CHG (charge) lamp flashes during charging under the following conditions:
The battery pack is not attached correctly.
The battery pack is damaged.
In the default setting, the power turns off automatically if you leave your camcorder without any
operation for about 5 minutes, to save battery power ([A.SHUT OFF]).






