Sony PCG-V505AC - Manual (Page 100)

Connecting a Port Replicator
You can connect a port replicator to the computer while the computer is on or off. Connecting a port replicator while the
computer is in a power saving mode (Standby or Hibernate) may result in data loss or a computer malfunction.
Use the AC adapter (not the battery) to power the computer while it is connected to a port replicator.
Moving the computer with the port replicator attached could disconnect the AC adapter or power cord, and may cause
the computer to lose power or malfunction.
To connect a port replicator
1. Close active programs to prevent data loss.
2. Turn off the computer, and disconnect all attached devices.
3. On the bottom of the computer, slide the port replicator cover down until the port replicator connector is
completely visible.
Sliding the Port Replicator Cov er
You can charge the battery by installing it before you connect the port replicator. The battery automatically
charges once you connect the AC adapter.
4. Plug the AC adapter into the DC IN port on the port replicator, and plug the power cord into the AC adapter and
an AC outlet. The power indicator turns on.
Connecting an AC Adapter to a Port Replicator
5. Align the connector on the bottom of the computer with the port replicator connector, and gently push the
computer down until it clicks into place.
Connecting a Port Replicator
Page 100