Sony DCR-TRV130 - Manual (Page 12)

12
Step 1 Preparing the power supply
Charging the battery pack
Use the battery pack after charging it for your camcorder.
Your camcorder operates only with the “InfoLITHIUM” battery pack (L series).
See page 93 for more information about “InfoLITHIUM” battery pack.
(1) Open the DC IN jack cover and connect the AC power adaptor supplied with
your camcorder to the DC IN jack with the plug’s v mark facing up.
(2) Connect the power cord to the AC power adaptor.
(3) Connect the power cord to a wall outlet.
(4) Set the POWER switch to OFF (CHARGE). Charging begins, and the CHG
lamp lights up.
When the CHG lamp goes out, the charging is completed.
After charging the battery pack
Disconnect the AC power adaptor from the DC IN jack on your camcorder.
Notes
•Prevent metallic objects from coming into contact with the metal parts of the DC plug
of the AC power adaptor. This may cause a short-circuit, damaging the AC power
adaptor.
•Keep the battery pack dry.
•When the battery pack is not to be used for a long time, charge the battery pack fully,
and then use it until it fully discharges again. Do this once a year. Keep the battery
pack in a cool place.
When the battery pack is charged fully
The CHG lamp goes out.
VCR POWER
OFF
CAMERA
(CHARGE
)
4
2
1
CHG lamp