Sony DCR-TRV130 - Manual (Page 27)

27
Playback – Basics
— Playback – Basics —
Playing back a tape
You cannot play back the tapes recorded in the Hi8 /Standard (analog) system.
Your camcorder plays back pictures only in the Digital8 system.
You can monitor the playback picture on the LCD screen. If you close the LCD panel,
you can monitor the playback picture in the viewfinder. You can control playback using
the Remote Commander supplied with your camcorder.
(1) Install the power source and insert the recorded tape.
(2) Set the POWER switch to VCR while pressing the small green button.
(3) Open the LCD panel while pressing OPEN.
(4) Press m to rewind the tape.
(5) Press N to start playback.
(6) To adjust the volume, press either of the two buttons on VOLUME. The
speaker on your camcorder is silent when the LCD panel is closed.
To stop playback
Press x.
When monitoring on the LCD screen
You can turn the LCD panel over and move it back to the camcorder body with the
LCD screen facing out [a]. You can adjust the angle of the LCD panel by lifting the LCD
panel up by 23 degrees [b].
3
6
2 5 4
VCR POWER
OFF
CAMERA
(CHARGE
)
REW PLAY
VOLUME
1
23
°
[a] [b]