Sony DCR-SR40 - Manual (Page 6)

6
Note
This equipment has been tested and found to
comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a
residential installation. This equipment generates,
uses, and can radiate radio frequency energy and,
if not installed and used in accordance with the
instructions, may cause harmful interference to
radio communications.
However, there is no guarantee that interference
will not occur in a particular installation. If this
equipment does cause harmful interference to
radio or television reception, which can be
determined by turning the equipment off and on,
the user is encouraged to try to correct the
interference by one or more of the following
measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment
and receiver.
– Connect the equipment into an outlet on a
circuit different from that to which the receiver
is connected.
– Consult the dealer or an experienced radio/TV
technician for help.
The supplied interface cable must be used with the
equipment in order to comply with the limits for a
digital device pursuant to Subpart B of Part 15 of
FCC Rules.
Battery pack
THIS DEVICE COMPLIES WITH PART 15 OF
THE FCC RULES.OPERATION IS SUBJECT
TO THE FOLLOWING TWO CONDITIONS:
(1) THIS DEVICE MAY NOT CAUSE
HARMFUL INTERFERENCE, AND (2) THIS
DEVICE MUST ACCEPT ANY
INTERFERENCE RECEIVED, INCLUDING
INTERFERENCE THAT MAY CAUSE
UNDESIRED OPERATION.
Battery pack
THIS CLASS B DIGITAL APPARATUS
COMPLIES WITH CANADIAN ICES-003.
Your camcorder is supplied with two
kinds of operations guides.
For operating and handling the camcorder,
refer to “Operating Guide” and “Handycam
Handbook” (PDF/this Handbook).
On using the camcorder
• Do not hold the camcorder by the following parts.
• The camcorder is not dust proofed, drip
proofed or waterproofed. See
“Maintenance and precautions” (p.121).
• To prevent the hard disk from being broken
or recorded images from being lost, do not
do the followings when either of the
respective lamps of the POWER switch
(p.21) or the ACCESS lamp (p.28, 30, 32)
is on:
– Removing the battery pack or AC
Adaptor from the camcorder
– Applying mechanical shock or vibration
to the camcorder
• Before connecting your camcorder to
another device with a USB cable etc., be
sure to insert the connector plug in the
proper direction. If you insert the connector
plug forcibly in the wrong direction, the
terminal may be damaged, or this may
cause a malfunction of your camcorder.
• Disconnect the AC Adaptor from the
Handycam Station holding both the
camcorder and the DC plug.
• Be sure to slide the POWER switch up to
OFF (CHG), when you set the camcorder
onto the Handycam Station or remove the
camcorder from it.
For customers in CANADA
Notes on use
LCD screen Battery