Sony DCR-SR40 - Manual (Page 56)

56
The default settings are marked with B.
The indicators in parentheses appear when
the items are selected.
See page 47 for details on selecting
setup items.
You can record several still images one after
another by pressing PHOTO.
B OFF
Select this when not recording continuously.
NORMAL ( )
Records still images continuously at
approximately 0.5 seconds intervals. The
numbers of the maximum recordable
images are as follows:
1.0M (
) : 8 images
VGA (0.3M) ( ) : 21 images
0.7M ( ) : 8 images
EXP. BRKTG ( )
Records 3 images consecutively with
different exposures at approximately 0.5
second intervals. You can compare the three
images and select an image recorded at the
best exposure.
• The flash will not function during continuous
recording.
• The maximum number of images will be recorded
in the self-timer mode or when you are operating
with the Remote Commander (DCR-SR60/
SR80).
• You may not be able to record continuous images
up to the maximum number depending on the
image size and the remaining hard disk space of
the camcorder.
• [EXP. BRKTG] does not function, if the hard disk
space is only available for less than three still
images.
• It takes longer to record continuous images to the
hard disk compared to normal recording. Record
the next still image after the scroll bar indicator
(
) and the ACCESS lamp turns off.
STILL SET
Settings for still images
(BURST/QUALITY/IMAGE SIZE, etc.)
BURST (DCR-SR60/SR80)
B FINE ( )
Records still images at the fine image quality
level.
STANDARD ( )
Records still images at the standard image
quality level.
The size of still images (Approx. kB)
B 1.0M ( )
Records still images clearly.
VGA (0.3M) ( )
Allows for the maximum number of images
to be recorded.
• When the aspect ratio is changed to 16:9 (wide),
the image size is changed to [ 0.7M] ( )
(p.26).
• The number of pixels for each image size is as
follows:
1.0M : 1152×864
VGA (0.3M) : 640×480
0.7M : 1152×648
• The maximum number of recordable still images
is 9,999.
• The image size of DCR-SR40 is set to [VGA
(0.3M)] ( ).
QUALITY
1.0M
0.7M
VGA
(0.3M)
FINE
(FINE)
500 380 150
STANDARD
(STD)
210 160 60
IMAGE SIZE (DCR-SR60/SR80)