Remote control – Sony HT-7000DH User Manual

Page 77

Advertising
background image

77

US

F:\Sony SEM HA\Revision3-
7000DH\JC06xxx_2662265122HT7000DH_US\2662265122\US07REM_HT-7000DH-U.fm

masterpage: Right

HT-8000MH

2-662-265-12 (2)

Ad
diti

on
al

I

n

fo

rmatio

n

Radio stations cannot be tuned in.

• Check that the antennas are connected

securely. Adjust the antennas and connect
an external antenna, if necessary.

• The signal strength of the stations is too

weak (when tuning in with automatic
tuning). Use direct tuning.

• Make sure you set the tuning interval

correctly (when tuning in AM stations
with direct tuning).

• No stations have been preset or the preset

stations have been cleared (when tuning by
scanning preset stations). Preset the
stations (page 61).

• Press DISPLAY repeatedly on the receiver

so that the frequency appears on the
display.

There is no picture or an unclear
picture appears on the TV screen or
monitor.

• Select the appropriate input using the input

buttons.

• Set your TV to the appropriate input mode.
• Move your audio components away from

the TV.

• Assign the component video input

correctly.

The MULTI CHANNNEL DECODING
lamp does not light up in blue.

• Check that the playback component is

connected to a digital jack and the input is
selected properly on this receiver.

• Check whether the input source of the

software being played back corresponds to
the multi channel format.

• Check whether the setup on the playback

component is set to multi channel sound.

The source image input to the HDMI
jack on the receiver is not output from
the TV.

• Check the HDMI connection.
• Depending on the playback component,

you may need to set up the component.
Refer to the operating instructions
supplied with the each component.

• Assign the HDMI input correctly.

Remote control

The remote does not function.

• Point the remote at the remote sensor on

the receiver.

• Remove any obstacles in the path between

the remote and the receiver.

• Replace all the batteries in the remote with

new ones, if they are weak.

• Make sure you select the correct input on

the remote.

• The 12 button on the remote is not

available for receiver operation.

continued

US01COV_HT-7000DH-U.book Page 77 Monday, August 14, 2006 9:22 AM

Advertising