Sony KD-34XBR960N - Manual (Page 22)

21
SETU
P
Set
up
S
E
TU
P
SETU
P
S
E
TU
P
SETU
P
Cable Box Only For best results, use this connection if:
❑
Your cable TV company scrambles all channels, which requires
you to use a cable box.
❑ You do not have a VCR. (If you have a VCR, see pages 24 and 26.)
With this connection you can:
❑
Use the TV remote control to change channels coming through
the cable box to the TV’s VHF/UHF jack. (You must first
program the remote control for your specific cable box.)
To connect the cable box
1 Connect the CATV cable to the cable box’s input jack.
2 Use a coaxial cable to connect the cable box’s output jack to the
TV’s VHF/UHF jack.
3 Run Auto Program, as described in “Setting Up the Channel List”
on page 45.
Notes on Using This Connection
About Using This Connection with Dual Picture (Twin View, etc.) Features
With this connection, all channels come into the TV through your cable box and only one
unscrambled signal is sent to the TV, so you cannot use the dual picture features.. If
some of your channels are scrambled, but others are not, consider using the “Cable Box
and Cable” connection on page 20 instead.
Before connecting a cable
box, see “About Using
CableCARD” on page 17.
1 2
OUT IN
VHF/UHF
cable
CATV
Coaxial cable TV
Cable box
To Do This ... Do This ...
Use the cable box Tune the TV to the channel the cable box is set to (usually channel 3 or 4)
and then use the cable box to switch channels.
Set up the TV remote control
to operate the cable box Program the remote control. See “Programming the Remote Control” on
pages 51.
Activate the remote control to
operate the cable box Press SAT/CABLE FUNCTION .
34XBR.book Page 21 Thursday, May 20, 2004 7:09 AM