Sony SDM-S95ER - Manual (Page 9)

9
US
Setup 4: Connect the power cord
If you use the fixed stand, draw the power cord through the stand
hole first and then connect them to the display. For more details
see “Setup 5: Secure the cords.”
1 Connect the supplied power cord securely to the
display’s AC IN connector.
2 Connect the other end securely to a power outlet.
Setup 5: Secure the cords
x Fixed Stand
Be sure that the cords and cables have been drawn into the stand
hole as illustrated.
x Height adjustable stand
Draw the cords and cables through the cable holder as illustrated.
Note
When bounding the cords and cables, be sure to loosen them a little. If
they get pulled hard they may come off from the connectors or plugs as
you adjust the screen angle. If you stretch the cords and cables too hard
they may get damaged.
Setup 6: Turn on the display and
computer
1 Press the 1 (power) switch located on the front
right of the display.
The 1 (power) indicator lights up in green.
2 Turn on the computer.
If no picture appears on your screen
• Check that the power cord and the video signal cables are
properly connected.
• If “NO INPUT SIGNAL” appears on the screen:
– The computer is in the power saving mode. Try pressing any
key on the keyboard or moving the mouse.
– Check that the input signal setting is correct by pressing the
OK button (page 11).
• If “CABLE DISCONNECTED” appears on the screen:
– Check that the video signal cables are properly connected.
– Check that the input signal setting is correct by pressing the
OK button (page 11).
to AC IN
to a power outlet
power cord (supplied)
1
2
lights in green