Sony HDR-UX10 - Manual (Page 133)

133
A
d
d
iti
o
n
a
l In
fo
rm
a
tio
n
3 Touch “×” displayed on the screen with the
corner of the “Memory Stick PRO Duo” or
the like 3 times. The position of “×”
changes.
Touch [CANCEL] to cancel.
If you did not press the right spot, try the
calibration again.
b Notes
• Do not use a sharp-pointed object for
calibration. Doing so may damage the LCD
screen.
• You cannot calibrate the LCD screen if it is
rotated, or closed with the screen facing out.
On maintenance of the casing
• If the casing is soiled, clean the camcorder body
with a soft cloth lightly moistened with water,
and then wipe the casing with a dry soft cloth.
• Avoid the following to avoid damage to the
finish:
– Using chemicals such as thinner, benzine,
alcohol, chemical cloths, repellent, insecticide
and sunscreen.
– Handling the camcorder with above
substances on your hands.
– Leaving the casing in contact with rubber or
vinyl objects for a long period of time.
On the pickup lens
• Do not touch the pickup lens inside the
disc cover. Keep the disc cover closed
except when inserting and removing the
disc, to keep dust out.
• When your camcorder does not work
because the pickup lens is dirty, clean it
with a blower (optional). Do not touch the
pickup lens directly during cleaning
because this may cause the camcorder to
malfunction.
About care and storage of the lens
• Wipe the surface of the lens clean with a soft
cloth in the following instances:
– When there are fingerprints on the lens
surface.
– In hot or humid locations
– When the lens is exposed to salty air such as
at the seaside.
• Store in a well-ventilated location subject to
little dirt or dust.
• To prevent mold, periodically clean the lens as
described above. It is recommended that you
operate your camcorder about once a month to
keep it in optimum state for a long time.
About care of the viewfinder
To remove dust from inside the viewfinder,
follow the procedure below.
1 Pull out the viewfinder.
2 While pushing in the tab on the bottom
of the viewfinder with a fine-tipped
implement such as a ball point pen, pull
the eyecup block in the direction of the
arrow to remove.
Pickup lens
Tab
Continued ,