Sony HDR-UX10 - Manual (Page 23)

23
Ge
tt
in
g
S
ta
rte
d
b Notes
• Disconnect the AC Adaptor from the DC IN
jack holding both the camcorder and the DC
plug.
To remove the battery pack
1 Slide the POWER switch to OFF
(CHG).
2 Press and hold the BATT (battery
release) button and remove the battery
pack in the direction of the arrow.
b Notes
• When you remove the battery pack or
disconnect the AC Adaptor, make sure that the
(Movie) lamp/ (Still) lamp (p. 25)/
ACCESS lamp (p. 30)/access lamp (p. 32) is
turned off.
• When storing the battery pack, fully discharge
the battery pack before storing it for an extended
period (see page 131 for the details of storage).
To use a power source from a wall
outlet (wall socket)
Make the same connections as you do when
charging the battery pack. The battery pack
will not lose its charge in this case.
To check the remaining battery
(Battery Info)
Set the POWER switch to OFF (CHG), then
press DISP/BATT INFO.
After a while, the approximate recordable
time and battery information appear for
about 7 seconds. You can view the battery
information for up to 20 seconds by
pressing DISP/BATT INFO again while the
information is displayed.
Charging time
Approximate time (min.) required when
you fully charge a fully discharged battery
pack.
Available recording time
Approximate time (min.) available when
you use a fully charged battery pack.
“ HD ” stands for high definition image quality,
and “ SD ” stands for standard image quality.
BATT (battery release) button
Battery pack Charging time
NP-FH50 135
NP-FH60 (supplied) 135
NP-FH70 170
NP-FH100 390
Remaining battery (approx.)
Recording capacity (approx.)
Continued ,