Sony HT-XT1 - Manual (Page 17)

17 US
Miscellaneou
s
BLUETOOTH
BLUETOOTH connection cannot be completed.
 Make sure that the illumination LED (blue) is lit (refer to “Listening
to the sound from BLUETOOTH devices” in the supplied Startup
Guide).
 Make sure the BLUETOOTH device to be connected is turned on
and the BLUETOOTH function is enabled.
 Bring this system and the BLUETOOTH device closer together.
 Pair this system and the BLUETOOTH device again. You may need
to cancel the pairing with this system using your BLUETOOTH
device first.
Pairing cannot be achieved.
 Bring this system and the BLUETOOTH device closer together
(refer to “Listening to the sound from BLUETOOTH devices” in the
supplied Startup Guide).
 Make sure this system is not receiving interference from a wireless
LAN equipment, other 2.4 GHz wireless devices, or a microwave
oven. If a device that generates electromagnetic radiation is
nearby, move the device away from this system.
No sound is output from the connected BLUETOOTH device.
 Make sure that the illumination LED (blue) is lit (refer to “Listening
to the sound from BLUETOOTH devices” in the supplied Startup
Guide).
 Bring this system and the BLUETOOTH device closer together.
 If a device that generates electromagnetic radiation, such as a
wireless LAN equipment, other BLUETOOTH devices, or a
microwave oven is nearby, move the device away from this
system.
 Remove any obstacle between this system and the BLUETOOTH
device or move this system away from the obstacle.
 Reposition the connected BLUETOOTH device.
 Try changing the wireless frequency of the Wi-Fi router, computer,
etc. to the 5 GHz band.
 Increase the volume on the connected BLUETOOTH device.
The sound is not in sync with the image.
 When you are watching movies, you may hear the sound with a
slight delay from the image.
REMOTE CONTROL
The remote control does not function.
 Point the remote control at the remote control sensor on the
system (refer to “Parts and controls” (page 19)).
 Remove any obstacles in the path between the remote control
and the system.
 Replace both batteries in the remote control with new ones, if they
are weak.
 Make sure you are pressing the correct button on the remote
control.
System status illumination LED status
During BLUETOOTH pairing Flashes quickly in blue
The system is attempting to connect
with a BLUETOOTH device Flashes in blue
The system has established
connection with a BLUETOOTH device Lit in blue
The system is in BLUETOOTH standby
mode (when the system is off) Unlit
continued