Sony KE-32TS2 - Manual (Page 10)

10
(US)
Installing and Connecting the TV
Connecting a VCR and Cable
Use this hookup if:
• You have cable TV that does not require a cable box.
Disconnect all power sources before making any connections.
1
Connect the cable TV cable to the VCR’s IN jack.
2
Using the supplied 75-ohm coaxial cable, connect the VCR’s OUT jack
to the TV’s VHF/UHF jack.
3
Using AUDIO and S VIDEO cables, connect the VCR’s Audio and S Video
OUT jacks to the TV’s AUDIO and S VIDEO IN jacks.
Tip
If your VCR is not equipped with S VIDEO, use a VIDEO cable (yellow) instead of the S
VIDEO cable.
When connecting both VIDEO OUT and S VIDEO OUT
You can select which jack the TV receives the input signal from on the menu
screen. You can set it for each video input (VIDEO IN 1 and VIDEO IN 2)
separately. The TV is factory set to receive S VIDEO input signals.
1 Press TV/VIDEO repeatedly until the desired video input appears.
2 Press MENU.
3 Press V/v to select (Custom Setup), then press .
4 Press V/v to select “Auto YC,” then press .
5 To watch the pictures input from the S VIDEO input jack:
Press
V/v to select “On,” then press .
To watch the picture input from the VIDEO input jack:
Press
V/v to select “Off,” then press .
6 Press MENU to exit the menu screen.
HD VD
IN
OUT
P B /B Y/G P R /R L R AUDIO
L R
VHF/UHF
AC IN
AUDIO OUT
VIDEO IN 4
SUB
WOOFER
CONTROL
S
VIDEO L R AUDIO L R AUDIO S VIDEO
VIDEO IN 1 VIDEO IN 3
VIDEO IN 2
DVI-HDTV
YC-15V/30V (not supplied)
VIDEO (yellow)
AUDIO-L (white)
AUDIO-R (red)
VMC-810S/820S
(not supplied)
VCR
Cable
S VIDEO
Rear of TV
75-ohm
coaxial cable
(supplied)