Ultra Start 007 - Manual (Page 7)

7. Program Start Mode
Page 7
How to Set the Engine Start
38 38 38
12:38 12:38 12:38
PS 8-20 PS 6-20 PS 6-20
P P P TMR TMR TMR
PRO PRO
RESET
ST.STP ST.STP
MODE
2 seconds
A A A
38 38 38
12:38 12:38 12:38
SU 5-16 PS 6-20 PS 6-20
A P P
PRO PRO
MODE ST.STP
A A
1. In real time mode, press the MODE button 4 times to enter the Program Start
mode.
2. Press the ST.STP button to change the ON/OFF function of the Program Start.
When the “PRO” icon is ON, the engine will start and run at the preset time. The
remote will beep three times to confirm starting of the engine. The remote start
will only activate when the system is armed and within RF operating range.
3. Press the MODE button to exit.
1. Press the MODE button to enter the Program Start Mode.
2. Hold the MODE button for 2 seconds, the hour digits will start flashing.
3. While the digits are flashing, press the ST.STP button to increase the number.
Hold down the ST.STP button to change the number at a greater speed.
4. To set the minute, press the RESET button.
5. After you set the hours and minutes, press the MODE button to exit and save.