Sony CMT-EP50 - Manual (Page 9)

CD
9
Programing the CD tracks
— Program Play
You can make a program of up to 32 tracks in
the order you want them to be played.
1
Press CD, then place a CD.
2
Press PLAY MODE (PLAY MODE/RDS/
DIR on the remote) repeatedly until
“PROGRAM” appears in the display.
3
Press . m or M > until the
desired track appears in the display.
4
Press ENTER (TUNER MEM/ENTER on
the remote).
The track is programed. The program step
number appears.
5
To program additional tracks, repeat
steps 3 to 4.
6
Press nN .
Program Play starts.
To
Cancel Program
Play
Add a track to
the end of the
program
Erase the entire
program
Tip
The program you made remains in the system’s
memory even after it has been played back. Press CD,
then press nN to play the same program again.
Preset number
Do this
Press PLAY MODE (PLAY
MODE/RDS/DIR on the remote)
until “PROGRAM” disappears
from the display.
Do step 3 and 4 with Program Play
stopped.
Press x once, when Program Play
is in stop mode, or twice during
Program Play.
Using the CD display
Press DISPLAY repeatedly.
The display changes as follows:
During normal play
Elapsed playing time on the current track t
Remaining time on the current track t
Remaining time on the current CD t Clock
display (for five seconds) t Elapsed playing
time on the current track t ...
In the stop mode
Total number of tracks and total playing time
t Clock display (for five seconds) t Total
number of tracks and total playing time
t ...
Selected track number
(including selected track)