Sony HT-CT60BT - Manual (Page 15)

15 US
Ge
tt
ing St
art
e
d
When the Sound Bar is to be placed
facing upward slightly or on a wall,
remove the two stands at the bottom
of the Sound Bar, as shown below.
 When the Sound Bar is placed facing
upward slightly with the stands
removed, take care not to block the
ventilation holes with carpet, etc.
You can install the Sound Bar on the
wall.
 Use screws that are suitable for the
wall material and strength. As a plaster
board wall is especially fragile, attach
the screws securely to a wall beam.
Install the Sound Bar on a vertical and
flat reinforced area of the wall.
 Be sure to subcontract the installation
to Sony dealers or licensed contractors
and pay special attention to safety
during the installation.
 Sony is not responsible for accidents or
damage caused by improper
installation, insufficient wall strength,
improper screw installation or natural
calamity, etc.
1
Prepare screws (not supplied)
that are suitable for the holes on
the back of the Sound Bar.
2
Fasten the screws to the wall.
The screws should protrude 7 to
8 mm (approx. 5/16 inches).
3
Hang the Sound Bar onto the
screws.
Align the holes on the back of the
Sound Bar to the screws, then
Removing the stands
Note
Installing the Sound Bar on
a wall
Notes
Stand
Hole on the back of the Sound Bar
4 mm
(3/16 inches)
more than 25 mm (1 inch)
5 mm
(7/32 inches)
10 mm
(13/32 inches)
380 mm
(15 inches)
7 to 8 mm
(approx.
5/16 inches)
continued