Sony DCR-TRV70 - Manual (Page 136)

136
Adjusting the LCD screen (CALIBRATION)
If the buttons on the touch panel do not work correctly, follow the procedure below.
(1) Set the POWER switch to OFF (CHG).
(2) Eject the tape from your camcorder, then disconnect any connecting cable from
your camcorder.
(3) Set the POWER switch to VCR while pressing DISPLAY/BATTERY INFO on
your camcorder, then keep pressing DISPLAY/BATTERY INFO on your
camcorder for about five seconds.
(4) Tap displayed on the screen with the supplied stylus.
The position of changes.
Notes
•If you do not tap the right spot, you need to repeat step 4.
•You cannot calibrate the LCD screen when you close the LCD panel with the LCD
screen facing out.
For details of adjusting the LCD screen (CALIBRATION), refer to the operating
instructions supplied with your camcorder.
Troubleshooting
CALIBRATE
Troubleshooting