Sony DCR-TRV70 - Manual (Page 25)

25
Preparation for Network Operation
Registering a Bluetooth device
To enable your camcorder to communicate with a Bluetooth device, the devices should
be registered with each other. Here we describe how to register the Sony Modem
Adaptor with Bluetooth Function. Once registration is complete, you do not have to
reregister the Bluetooth device as long as you do not cancel registration. You can
register up to three Bluetooth devices to your camcorder. Refer also to the operating
instructions supplied with each Bluetooth device.
For details of Bluetooth devices compatible with your camcorder, access the following
URL: “http://www.myimagecam.com/”
Using the Modem Adaptor with Bluetooth Function
Connect your camcorder to a Bluetooth device by Bluetooth wireless technology.
Notes
•When using Sony BTA-NW1/BTA-NW1A Modem Adaptor with Bluetooth Function,
place it so that there are no obstacles between your camcorder and the device. The
distance between the devices must be within 10 m (33 feet).
•The connection may be interrupted depending on the communication conditions.
•When your camcorder is connected to a USB device, your camcorder cannot
communicate via a Bluetooth device.
•Do not remove the battery pack while your camcorder is communicating with
Bluetooth devices. Doing so may cause malfunction of your camcorder.
1 Preparing a Modem Adaptor with Bluetooth Function
Set a Modem Adaptor with Bluetooth Function to connection standby (BONDING). For
details, refer to the operating instructions supplied with the Modem Adaptor.
Registering Bluetooth devices
Modem Adaptor with Bluetooth
Function (not supplied)
your camcorder