Sony DCR-DVD203 - Manual (Page 68)

68
DCR-DVD92/DVD103/DVD203/DVD403/DVD602/DVD653/DVD703/DVD803
2-587-622-11 (1)
REMOTE CTRL (Remote control)
(Except for DCR-DVD92/DVD602)
The default setting is [ON] so that you can
use the Remote Commander (p. 41).
• Set to [OFF] to prevent your camcorder
from responding to a command sent by other
equipment’ remote control.
• The setting returns to [ON] when you have
the power source disconnected from your
camcorder for more than 5 minutes.
REC LAMP (Recording lamp)
The camera recording lamp will not light
up during recording when you set this to
[OFF]. (The default setting is [ON].)
BEEP
 ON
A melody sounds when you start/stop
recording, or operate the touch panel.
OFF
Cancels the melody.
DISP OUTPUT
 LCD PANEL
Shows displays such as the counter on the
LCD screen and in the viewfinder.
V-OUT/PANEL
Shows the display also on the TV screen.
SETUP ROTATE
 NORMAL
Scrolls the setup items downwards by
touching
.
OPPOSITE
Scrolls the setup items upwards by
touching
.
DATE/TIME
 Date
 Time
• appears for an image recorded using a flash.
• The data code is displayed on the TV screen if
you connect your camcorder to a TV.
• The indicator toggles through the following
sequences as you press DATA CODE on
the remote commander: DATE/TIME

CAMERA DATA  OFF (no indication)
(Except for DCR-DVD92/DVD602).
• Depending on the disc condition, Bars [--:--:--]
appear.
• The setting returns to [OFF] when you have
the power source disconnected from your
camcorder for more than 5 minutes.
DISC REMAIN
 AUTO
Displays the remaining disc indicator for
about 8 seconds in situations such as those
described below.
• When you check the disc remaining by
sliding the POWER switch down to
(Movie) or
(Still).
• When you set the POWER to (Movie)
or (Still), then press the DISP/BATT
INFO to switch the indicator off to on.
• When the remaining capacity of the disc is
less than 5 minutes for (Movie) or 30
images for (Still).
• When you start recording from the line
input.
ON
Always displays the remaining disc
indicator.
STANDARD SET (continued)