Error displays/messages, 34 error displays/messages – Sony CDX-M3DI User Manual

Page 34

Advertising
background image

34

Error displays/Messages

*1

When the CD/MD changer is connected to the unit,
the disc number of the CD or MD appears in the
display.

*2

The disc number of the disc causing the error
appears in the display.

Radio reception

Preset tuning is not possible.

• Store the correct frequency in the memory.
• The broadcast signal is too weak.

The stations cannot be received.
The sound is hampered by noises.

• Connect a power antenna control lead (blue)

or accessory power supply lead (red) to the
power supply lead of a car’s antenna booster.
(Only if your car has a built-in FM/AM
antenna in the rear/side glass.)

• Check the connection of the car antenna.
• The auto antenna will not go up.

t Check the connection of the power

antenna control lead.

• Check the frequency.
• When the DSO mode is on, the sound is

sometimes hampered by noises.
t Set the DSO mode to “OFF” (page 26).

Automatic tuning is not possible.

• The local seek mode is set to “ON.”

t Set the local seek mode to “OFF”

(page 25).

• The broadcast signal is too weak.

t Perform manual tuning.

The “STEREO” indication flashes.

• Tune in the frequency accurately.
• The broadcast signal is too weak.

t Set to the monaural reception mode

(page 25).

A program broadcast in stereo is heard in
monaural.

The unit is in monaural reception mode.
t Cancel monaural reception mode

(page 25).

Interference occurs during FM reception.

The wide mode is selected.
t Set the IF mode to “IF AUTO” (page 25).

Error displays

(For this unit and optional CD/MD changers)

The following indications will flash for about
5 seconds, and an alarm sound will be heard.

Blank

*

1

No tracks have been recorded on an MD*

2

.

t Play an MD with recorded tracks on it.

Error

*

1

• A CD is dirty or inserted upside down.*

2

t Clean or insert the CD correctly.

• A CD/MD cannot play because of some

problem.*

2

t Insert another CD/MD.

High Temp

The ambient temperature is more than 50°C
(122°F).
t Wait until the temperature goes down

below 50°C (122°F).

NO Disc

No disc is inserted in the CD/MD unit.
t Insert discs in the CD/MD unit.

NO Magazine

The disc magazine is not inserted in the CD/
MD unit.
t Insert the magazine in the CD/MD unit.

NO Music

*

1

A CD which is not a music file is inserted.
t Insert a music CD.

Not Ready

The lid of the MD unit (MDX-40) is open or
the MDs are not inserted properly.
t Close the lid or insert the MDs properly.

Push Reset

The CD/MD unit cannot be operated because
of some problem.
t Press the reset button on the unit.

Advertising