Airlink101 AIC250W - Manual (Page 8)

8
4. Gathering Information
Note: Before using the Setup Wizard, you’ll need to take note of your local network
address and wireless settings.
Step 1 Click on Start, Run, and type command (for Windows 95/98/ME) or cmd (for
Windows 2000/XP) and click OK. The command prompt will appear.
Step 2 At the command prompt, type ipconfig and press Enter.
Step 3 Write down the information for the IP Address, Subnet Mask, and Default
Gateway.
Step 4 Write down the following values for your wireless settings:
1. Network ID (SSID)
2. Channel Number
3. Wireless Encryption Settings
The IP Camera needs to use the same wireless settings in order for it to work properly.
You may gather these information from the web configuration utility of your wireless
router.