Airlink X EV-DO - Manual (Page 57)

Raven X EV-DO for Verizon - User Guide, version 2.34 51
AT Commands
FIGURE 10. HyperTerminal: Comport Settings
4. Type AT and press Enter. You should get a reply of “OK” or “0”. .
5. To see what you are typing as you type it, you will need to turn on the echo and verbose mode.
Type ATE1V1 and press Enter.
If you get a reply of “OK”, then you entered the command successfully. If you get a reply of “0” or
“ERROR”, try entering the command again.
Using AT Commands with a Terminal Application
• The following pages list the AT commands, their parameters, and explain what they do. For
most commands, when you are entering them using a terminal connection, you will need to
preface the command with AT (exceptions are noted), i.e. ATA which listed as A
• Some commands have specific parameters while other commands will take whatever you type.
• Acceptable parameters and/or specific formats are in the parameters column.
• Required variable parameters are denoted with italicized text, example, Dn . The n is variable
and noted in the parameters column.
• Optional parameters are denoted with square brackets [ ] .
• Most commands with parameters can be entered with ? to read the current value (for example,
AT&D? will respond with “2” if the default has not been changed).
• AT Commands are not case sensitive. A capital “E” is the same as a lower-case “e”.
• When you are using a terminal connection, if you enter a command which is recognized by the
Raven X, it will respond with “OK”. If the command is not recognized, the response will be
“ERROR”.
• Those commands applicable only to certain model numbers of the Raven X will be noted.
Caution: Symbols listed with commands, such as / , & , or ? , are part of the com-
mand and must be included.