Airlink X EV-DO - Manual (Page 62)

Raven X EV-DO for Verizon - User Guide, version 2.34 56
AT Commands: Information and Status
&V
+ECIO?
+PRL?
• Data Connection Failed
The Raven X failed to connect, and it is now waiting a set time interval before it attempts to
reconnect. Verify settings to activate the Raven X.
• Network Negotiation Fail
Network connection negotiation failed. This is usually temporary and often clears up dur-
ing a subsequent attempt.
• Network Ready
The Raven X is connected to the EV-DO network and ready to send data.
• Network Dormant
The Raven X is connected to the EV-DO network, but the link is dormant. It will be woken up when
data is sent or received.
• No Service
There is no EV-DO network detected.
• Hardware Reset
The hardware module is being reset. This is a temporary state.
*PRLSTATUS
The status of the most recent PRL Update.
• 0 : None
• 1 : In Progress
• 2 : Success
• Any other value : Failure
View active profile (the contents of the active registers).
Not displayed with Wireless Ace.
The CDMA EC/IO value.
Preferred Roaming List (PRL) version.
Information Displayed in Wireless Ace without AT Commands Listed
• Bytes and Packets Received and Sent
Network traffic for the applicable port.
• Number of System Resets
Counter of the number of system resets over the life of the modem or since the configuration
was reset.