Sony PCG-FXA33 - Manual (Page 90)

Change text in this variable definition to document title.
90
❑ If you are using an external display, check that it is plugged into a power
source and turned on. Check that the brightness and contrast controls are
adjusted correctly. See the manual that came with the display for details.
❑ Condensation may cause the notebook to malfunction. If this occurs, do not
use it for at least one hour.
❑ Take the battery pack out of the notebook, unplug the power cord, plug it in
again, and then turn on the power.
My notebook starts but a BIOS error appears.
❑ When the internal backup battery is low on power, it may not start your
system properly. The message, “Press <F1> to resume, <F2> to setup”
appears at the bottom of the screen. Follow these steps:
1 Press F2. The BIOS Setup menu appears.
2 Set the date (month/day/year). Press Enter.
3 Press to select System Time, and then set the time (hour: minute:
second). Press Enter.
4 Press to select Exit, and then press to select Get Default Values.
The message “Load default configuration now?” appears.
5 Select Yes and then press Enter.
6 Select Exit (Save Changes), and then press Enter. The message “Save
Configuration changes and exit now?” appears.
7 Select Yes, and then press Enter. The notebook restarts.
My notebook starts, but the message “Operating system not
found” appears and Windows does not start.
❑ Make sure there is no floppy disk in the floppy disk drive (non-bootable).
❑ If a non-bootable floppy disk is in a connected floppy disk drive, follow
these steps:
1 Turn off the notebook, and then remove the floppy disk.
✍
If this occurs on a regular basis, contact Sony PC Support
(http://www.sony.com/pcsupport/).