Sony DCR-TRV480 - Manual (Page 60)

Playback 60
Locating a scene on a
tape for playback
Searching quickly for a desired
scene – Zero set memory
1
During playback, press ZERO SET
MEMORY on the Remote
Commander at the point you want to
locate later on.
The tape counter is reset to “0:00:00” and
appears on the screen.
If the tape counter is not displayed, press
DISPLAY on the Remote Commander.
2
Press (stop) when you want to
stop playback.
3
Press m REW.
The tape stops automatically when the tape
counter reaches “0:00:00.”
4
Press PLAY.
The playback starts from the point
designated “0:00:00” on the tape counter.
To cancel the operation
Press ZERO SET MEMORY on the Remote
Commander again.
b Notes
• There may be a discrepancy of several seconds
between the time code and the tape counter.
• Zero set memory will not function correctly if there
is a blank section between recorded sections on the
tape.
• For DCR-TRV480:
The zero set memory function does not work with
tapes recorded on other devices in the Hi8
/
standard 8 mm system.
Searching for a scene by date of
recording – Date search
You can locate the point where the recording
date changes.
1
Slide the POWER switch repeatedly to
select the PLAY/EDIT mode.
2
Press SEARCH M. on the Remote
Commander repeatedly to select
[DATE SEARCH].
PLAY
ZERO SET MEMORY
DISPLAY
STOP
m REW
0:00:00 60min
P-MENU
20
. / >
SEARCH M.
STOP