Sony MDR-ZX300IP User Manual

Stereo headphones, How to use / utilisation / utilización, Mdr-zx300ip

Advertising
background image

©2012 Sony Corporation

Printed in Thailand

How to use / Utilisation / Utilización

Specifications

Headphones

Type: Closed, dynamic (supra-aural) / Driver

unit: 30 mm, dome type (CCAW Voice Coil) /

Power handling capacity: 1,000 mW (IEC*) /

Impedance: 24 Ω at 1 kHz / Sensitivity: 102

dB/mW / Frequency response: 10 Hz –

24,000 Hz / Cord: 1.2 m (47

1

/

4

in), Y-type /

Plug: Four-conductor gold-plated L-shaped

stereo mini plug for iPod/iPhone/iPad with

remote function / Mass: Approx. 120 g (4.23

oz) without cord

Microphone

Open circuit voltage level: – 42 dB (0 dB=

1 V/Pa)
* IEC = International Electrotechnical

Commission

Design and specifications are subject to

change without notice.

English

Stereo headphones

Using the Center button

Plays/pauses a track of the connected iPod

product with a single press. Skips to the next

track with a double press. Skips to the

previous track with a triple press. Starts the

“VoiceOver*” feature with a long press (if

available).

Press once to answer the call. Press again to

end. Hold down for about two seconds to

reject an incoming call. When you let go, two

low beeps confirm the call was rejected.
* Availability of the “VoiceOver” feature

depends on iPod and its software version.

Note

Be careful not to unintentionally press any

buttons when you carry your iPod with this

unit connected.

Precautions

High volume may affect your

hearing. For traffic safety, do

not use while driving or cycling.

You are cautioned that any changes or

modifications not expressly approved in this

manual could void your authority to operate

this equipment.

Optional replacement earpads can be

ordered from your nearest authorized Sony

retailer or www.sony.com.

Compatible iPod/iPhone/iPad

models

You can use the unit with only the following

models supporting remote control. Update

your iPod, iPhone or iPad to the latest software

before use. In the Operating Instructions, iPod,

iPhone and iPad are collectively described as

“iPod” except in special cases.

 iPod touch (5th generation)

 iPod touch (4th generation)

 iPod touch (3rd generation)

 iPod touch (2nd generation)

 iPod nano (7th generation)

 iPod nano (6th generation)

 iPod nano (5th generation)

 iPod nano (4th generation)

 iPod classic 120GB 160GB (2009)

 iPod shuffle (4th generation)

 iPod shuffle (3rd generation)

 iPhone 5

 iPhone 4S

 iPhone 4

 iPhone 3GS

 iPad (4th generation)

 iPad (3rd generation)

 iPad 2

 iPad

 iPad mini

On copyright

iPad, iPhone, iPod, iPod classic, iPod nano,

iPod shuffle, and iPod touch are trademarks of

Apple Inc., registered in the U.S. and other

countries.

“Made for iPod,” “Made for iPhone,” and “Made

for iPad” mean that an electronic accessory

has been designed to connect specifically to

iPod, iPhone or iPad, respectively, and has

been certified by the developer to meet Apple

performance standards. Apple is not

responsible for the operation of this device or

its compliance with safety and regulatory

standards.

* There is a tactile dot beside Volume +.

* Vous pouvez remarquer un point tactile à côté de Volume +.

* Hay un punto táctil al lado de Volumen +.

Volume +*

Volume +*

Volumen +*

Volume –

Volume –

Volumen –

Microphone

Micro

Micrófono

Center button

Touche centrale

Botón central

MDR-ZX300iP

Stereo Headphones

Operating Instructions

Mode d’emploi

Manual de instrucciones

4-286-563-12(1)

Advertising