Sony MVC-FD97 - Manual (Page 82)

masterpage:Left
filename[D:\WORKS\Mavica\3rd\3066743111\3066743111MVCFD97UC\02GB-
MVCFD97UC\09add.fm]
82
model name1[MVC-FD97]
[3-066-743-11(1)]
Reinstall the USB driver when using Windows 98, Windows
98SE, Windows Me and Windows 2000 Professional
Your computer does not
recognize your camera. • The battery level is low.
t Use the AC power adaptor (page 13).
• The camera is turned off.
t Turn on the camera.
• The USB cable is not connected firmly.
t Disconnect the USB cable, and connect it again
firmly. Make sure that “USB MODE” is
displayed on the LCD screen or on the finder
(page 31).
• The USB connectors on your computer are
connected to other equipment besides the keyboard,
the mouse, and your camera.
t Disconnect the USB cables except for the ones
connected to the keyboard, the mouse, and your
camera.
• The position of the MS/FD selector is not set to the
proper position for the media being used.
t Set the MS/FD selector to the proper position.
• The USB driver is not installed.
t Install the USB driver (page 31).
• For Windows 98, Windows 98SE, Windows
Me and Windows 2000 Professional users
Since the camera is connected to a computer with
the USB cable before installing the USB driver, the
drive is not recognized properly by the computer.
t Delete the drive which is not recognized
properly, then install the USB driver. For details,
see the procedure below.
1 Turn on your computer and allow Windows to load.
2 Connect the USB jack on the camera and the computer with the
supplied USB cable.
3 Insert a media and set the MS/FD selector to the appropriate
position according to the media inserted.
4 Connect the AC power adaptor to your camera and then to a wall
outlet (mains), and turn on the power of your camera.
Symptom Cause and/or Solution
01cov.book Page 82 Wednesday, January 17, 2001 9:10 AM