Sony SAT-HD300 - Manual (Page 25)

24
3-4. Connecting to Antennas - Round Dish (Satellite A)
Receiving Signals
1. Connect the “Antenna” to the “ANT IN” jack on the DIRECTV ® HD Receiver using a coaxial RF cable.
2. Connect the cable TV signal to the “CABLE IN” jack on the DIRECTV HD Receiver using a coaxial RF
cable.
3. Connect the “Jack 1” of the dish antenna to the “SATELLITE IN” jack on the DIRECTV HD Receiver using
a coaxial RF cable. (For proper dish installation, refer to the “Installer’s Guide” provided with your satel-
lite dish antenna.)
4. Connect the “Phone Wall Jack” to “PHONE JACK” on the DIRECTV HD Receiver using a phone cable.
(1080i/720p/480p) (1080i/720p/480p)
RGB OUT
DATA PORT
DVI-HDTV OUT
SATELLITE
IN
TYPE
CABLE IN
ANT IN
OUT TO TV
Y
COMPONENT OUT
(1080ii/720p/480p/480ii)
Pr
1
L2
R2 R1
L1
2
AUDIO OUT
Pb
OPTICAL
DIGITAL
AUDIO
OUT S VIDEO
OUT
VCR
CONTROL
RF
REMOTE
(1080ii/720p/480p/480ii)
PHONE
JACK
VIDEO OUT
LNB
Sat A
Dish
Jack 1
Phone wall jack
Antenna
Cable TV
wall jack
NOTE
While you are subscribing to a DIRECTV ® pro-
gramming package, you can still view over-the-
air and cable TV programs, if you make con-
nections to the over-the-air and/or cable jacks.
NOTE
A triple LNB multi-satellite dish with a SAT
C LNB is required to receive all DIRECTV ®
High-Definition programming, along with
this DIRECTV HD Receiver.