Sony CPD-G400 - Manual (Page 6)

6
D:\###sagyou\08 gatu\0827-y\386760621CPD-G400\01US03BAS-UC.fm masterpage:Left
CPD-G400
3-867-606-21 (1)
Setup
Before using your monitor, check that the following accessories
are included in your carton:
• Power cord
• Macintosh adapter (1)
• Windows Monitor Information Disk
• Warranty card
• Notes on cleaning the screen’s surface
• This instruction manual
Step 1: Connect your monitor to
your computer
Turn off the monitor and computer before connecting.
Notes
• Do not touch the pins of the video signal cable connector as this might
bend the pins.
• When connecting the video signal cable, check the alignment of the
HD15 connector. Do not force the connector in the wrong way or the
pins might bend.
x Connecting to an IBM PC/AT or compatible
computer
x Connecting to a Macintosh or compatible
computer
* Connect the supplied Macintosh adapter to the computer before
connecting the cable. This adapter is compatible with Macintosh LC,
Performa, Quadra, Power Macintosh and Power Macintosh G3 series
computers (sold before January, 1999). If you are connecting to a
Power Macintosh G3 series that sold after January 1999, you will need
a different adapter (not supplied). Macintosh II series and some older
versions of PowerBook models may need an adapter with micro
switches (not supplied).
x Connecting to a second computer
AC IN
1
(HD15)
2
(HD15)
IBM PC/AT or
compatible computer
to video output
AC IN
1 (HD15) 2 (HD15)
Use the supplied Macintosh adapter.
Macintosh adapter (supplied) *
Macintosh or
compatible computer to video
output
AC IN
1 (HD15) 2 (HD15)
Refer to the preceding examples
to connect your computer.
HD15 video signal
cable (not supplied)
to video input 2
connector (
y 2)