AT&T E5630 - Manual (Page 4)

2
Battery & charger installation
After installation, place the handset in the charger and allow the
battery to charge for 12 hours before use.You can keep the battery
charged by returning the handset to the charger after each use.
When battery power is fully depleted, a full recharge takes about 10
hours.Average talk time on a fully charged battery is about eight
hours depending on environmental conditions, standby time is
approximately four days.
Light remains on while
battery is charging.
Plug power cord into jack on
underside of charger, then plug
transformer into electrical outlet.
Insert supplied
battery.
Low battery indicator
Return handset to base or
charger to recharge when
this symbol flashes.
(Handset will beep when
battery is low.)
Caution: Use only supplied
rechargeable battery or AT&T
replacement battery model 2420 (SKU
00578. Part number 80-5542-00-00).
LOW BATTERY
Press tab to open
battery
compartment.
Then replace
compartment
cover.
91-000341-010-000-E560-1 Manual draft.qxd 2/13/1950 7:21 PM Page 4