Panasonic TY42TM4Y - Manual (Page 3)

3
English
2. Installing desired Terminal Board:
( Example : When installing Tuner Terminal Board )
1. Insert the desired Terminal Board into the slot until
it is firmly plugged into the card connector.
• Make sure that the Board does not ride on the
two lower claws.
2. Secure using the previously removed screws or
those supplied with the unit.
Tighten screws in the numbered order 1 - 4 .
Side grip
Screws (x4)
Slot
Avoid riding on claws.
Terminal function label
(accessory)
1. Removing the dummy cover or mounted
terminal board from display:
1.
Remove the four screws that secure the Terminal
Board to the rear of the display.
2. Hold the Terminal Board by the side grip and slowly
pull it out in the direction of the arrow.
3. Applying the terminal function label:
Peel off the backing sheet from the terminal function
label (accessory) and affix it over the existing label.
• Make sure that the label is affixed with the correct
position.
Have the customer keep the removed Terminal Board for future servicing needs.
( Example : When installing Tuner Terminal Board )
( Example : When removing RCA Terminal Board )
Precautions:
• Before installation
Turn the power switch off and pull out the plug.
Disconnect any plugs connected to the Plasma Display.
• When removing or installing the Terminal Board, exercise care to avoid injury.
There may be some sharp-pointed solder joints on the rear side of the Board that could cause unexpected
injury.
• When installing the Board, note the following point:
Fully insert the Board into the slot horizontally until it is firmly plugged into the connector. Note that
incomplete insertion may damage the internal components.
･ Place the Plasma Display upside down on a soft surface,
such as a foam mat.
• Before proceeding with the replacement steps, be sure to turn off the entire system including the display, unplug
all components from their outlets, and disconnect all the interconnect cables from the display.
Foam mat or thick
soft cloth