Panasonic TYCE42PS1 - Manual (Page 3)

3
To affix the label:
Peel off the rear protective sheet of the Terminal name indication
label.
As shown in the figure below, affix the Terminal name indication label to the rear of the Plasma Display below the
Terminals and next to the PC IN and SERIAL IN Indication label.
Affixing the Terminal name indication label
After completing installation of the Terminal Board, affix the included Terminal name indication label to the Plasma
Display.
Install the Terminal Board in the terminal slot at the rear of the Plasma Display.
Before installation
• Turn the power switch off and pull out the plug.
• Disconnect any plugs connected to the Plasma Display.
Foam mat or thick
soft cloth
Note : Retain the cover or terminal board that has been removed in a safe location for potential future use.
English
Rear of Plasma Display
Terminal name
indication label
Install
1 Place the Plasma Display upside down on a soft sur-
face, such as a foam mat.
4 Secure using the 4 screws removed at step 2 above.
Tighten screws in the numbered order (
– ).
2 Remove the 4 screws securing the slot cover or a
currently installed terminal board and remove the
cover or terminal board.
Note : The 4 screws are required for reassembly so
should be retained.
3 Confirm that the Terminal Board is correctly orientated
then carefully and slowly insert into the slot.
Ensure that the Board is completely seated.
Terminal name
indication label
PC IN and SERIAL IN
Idication label