Panasonic KXTGA648EX - Manual (Page 5)

5
Battery installation/Battery charge
Important:
• Use the supplied rechargeable batteries. For replacement, we recommend
using the Panasonic rechargeable batteries noted in the base unit’s operating
instructions.
• Wipe the battery ends (S, T) with a dry cloth.
• Avoid touching the battery ends (S, T) or the unit contacts.
• Confirm correct polarities (S, T).
• USE ONLY Ni-MH batteries AAA (R03) size.
• Do NOT use Alkaline/Manganese/Ni-Cd batteries.
Place the handset on the charger for about 7 hours before initial use.
Note:
• The handset display may show “Please wait for 1 minute.” when the
handset is placed on the charger if it is not registered to the base unit.
• If the batteries are fully charged, but the operating time seems to be shorter,
clean the battery ends ( S , T ) and the charge contacts with a dry cloth and
charge again.
Registering the handset to the base unit
Ensure that the handset is switched on. If it is not on, press and hold {ic} for
few seconds to turn the handset on.
1 Handset:
Lift the handset and press {ic}.
2 Base unit:
Press and hold {x} for about 5 seconds, until the registration tone sounds.
• If all registered handsets start ringing, press the same button to stop. Then
repeat this step.
3 Handset:
Place the handset on the base unit.
• Continue the operation even when the handset display shows
“Please wait for 1 minute.”.
4 With the handset still on the base unit, wait until a confirmation tone sounds
and w stops flashing.
Note:
• If an error tone sounds, or if w is still flashing, register the handset according
to the base unit’s operating instructions.
When the language selection is displayed after installing the batteries
for the first time, you can select your desired language.
{V}
/{^}: Select your desired language. i M i {ic}
TGA648EX(ex).book Page 5 Friday, May 22, 2009 1:58 PM