AT&T PLUG&SHARE 6602G - Manual (Page 4)

Installation
AT&T Plug&Share ™ Wireless USB Adapter 54 Mbps 6602G 4
Plug the adapter into a configured USB port in your computer (or use the supplied cable to connect it as
shown below).
Install software BEFORE installing the adapter (see Step 1 on previous page).
CAUTION: Turn OFF and UNPLUG your computer before opening it.
STEP 3: Recognize the Hardware
Depending on the Windows ® operating system version running on your computer, one of several screens
may appear to inform you that the computer recognizes new hardware. Choose to install the software
automatically and click Next.
Depending on your Windows ® version, you may see a Hardware Alert message or a Digital Signature
Not Found message. Click Continue Anyway or Yes to complete the installation.
Depending on your Windows ® version, you may have to restart your computer to complete the
installation. If a Windows ® message prompts you to restart your computer, do so.
Finally, some versions may display the message Systems Settings Change. Click Yes.
Check the indicator light to verify that the adapter is working: The light will remain on when receiving
power and connected to the network. It will blink during data transfer.
STEP 2: Install the Wireless USB Adapter
Connect to port
with this symbol
USB cable
Connect USB adapter to
cable (or computer)
Proceed to Step 2 only after the software has been correctly installed.
If correctly installed, a Utility icon (four vertical bars) should appear next to your
computer’s time display. An “X” indicates that software installation was successful,
but the wireless adapter is not yet activated.
Grasp end cap on sides
and pull to remove
Press button to release antenna
and raise to fully upright position