Panasonic TYST58PF20 - Manual (Page 19)

19
3. Fitting to the stand
Note
Before fitting the plasma display, make sure to lock the
casters.
1. Fitting plasma display
 Engage the upper insulation spacers of the
plasma display with the cutouts at the top of the
mobile stand, and slowly lower the plasma display
into place.
 While lifting the plasma display slightly, insert the
bottom insulation spacers into the holes at the
lower end of the mobile stand, and then lower the
plasma display straight down into place.
Caster locked
Push the
bottom of
the lever Push the
top of the
lever
Caster unlocked
Locking and unlocking the casters
2. Fixing of the plasma display
Firmly tighten the two screws for securing unit  in
the holes of the top bracket for plasma display  .
(Tightening torque: 1.5 to 2 N•m)
Note
Make sure to fit the screws for securing unit  on the left
and right to prevent the plasma display from coming off.
Mark A: 58-inch
Mark B: 42/50-inch
No mark: Spare
A B B A
A B B A
CAUTION
If the plasma display is lifted too much, it will fall down
and personal injury may result.
English
Cutout at top
Upper insulation spacer
Hole at bottom
Lower
insulation
spacer


Holes for screws for securing unit
(Use screw holes above cutouts
with insulation spacers inserted)
Screw for securing unit 