Panasonic TYWK4P1RW - Manual (Page 5)

5
English
5
3. Installing the wall-hanging bracket on
the wall
ヂ Install the wall-hanging bracket so that the arrows indicated
on it are pointing upward.
ッ First of all, secure the screw in the upper center hole ㅀ.
ツ Use a level to ensure that the fixture is not tilting on one
side, and then secure the screws in the five remaining
holes.
Arrows
ㅀ
Notes
• If it is necessary to embed bolts or nuts in the wall prior to installing
the wall-hanging bracket because the wall is made of concrete,
for instance, locate the positions of the holes by putting the actual
wall-hanging bracket in place on the wall or by calculating the hole
positions from the outline drawing, and then embed bolts and nuts
with a nominal diameter of 6 mm (0.2 inches) or their equivalent.
When embedding the bolts, ensure that their heads protrude by 10
to 15 mm (0.4 to 0.6 inches) from the surface of the wall.
• For installing the wall-hanging bracket onto the wall, use screws
with a nominal diameter of 6 mm (0.2 inches) or their equivalent
available from a hardware store and suited to the materials of the
installation area on the wall.
• Anchor the screws in at least six locations.
4. Adjusting the angle of the wall-hanging bracket.
ヂ The angle of this wall-hanging bracket can be adjusted in 5-degree increments to one of five positions ranging
from “zero tilting” to “20-degree tilting.”
When the wall-hanging bracket is shipped from the manufacturing plant, the angle is set to “zero tilting.” To
change this angle, remove the screws used for adjustment and change the position of the stay.
(Tightening torque: 1.2 to 1.5 N•m)
“20-degree tilting”
“Zero tilting”
“15-degree tilting”
“10-degree tilting”
“5-degree tilting”
Stay
“Zero tilting”
Tilting from 5 to 20
degrees
When the angle is set
to”Zero tilting”
When the angle is set
to”15-degree tilting”
Surface of wall
Screw used for
adjustment.
Surface of wall
Note
• When using some types of HDMI cables (RP-CDHG80 or RP-CDHG100) or PC cables, the cable may touch the wall and
cause damage to the HDMI terminal or the PC input terminal on the television set.
In such a case, adjust the angle of the wall-hanging bracket so that no weight is applied to the cable.