Panasonic CZRWSU2 - Manual (Page 23)

13. Miscellaneous Settings
EN-19
EN
A variety of changes can be made to settings, depending on the indoor unit being used.
Wind Direction (fl ap) indicator, operation mode indicator, time display (24 hour, AM/
PM), Heat Max Temp
• For information about the fl ap function, refer to the users’ manual of the unit being used.
• (These settings are saved in nonvolatile memory in the remote control, so even when its batteries are changed,
the settings do not have to be made again.)
• First check the display of the remote control when the unit is stopped and then make any desired settings.
How to Operate
• While holding down the buttons below, every time is pressed the remote control’s display changes.
• Whatever is being displayed when you release is set.
Setting Item Operation Button Setting Content Remote Control Display
Remote control fl ap
display setting for
when is pressed
Press
while pressing
Models with movable
fl aps
Swing only models
Models w/o lamps None
Remote control
operation mode
display setting when
is pressed
Press
while pressing
Heat Pump
(with Auto)
Heat Pump
(without Auto)
Dedicated air conditioner
Clock display setting
Press
while pressing
24 Hour
AM/PM
Max possible temperature
setting in the Heat mode
Press
while pressing
Maximum heating
temperature range is
26 °C – 30 °C
Instruction_honbun_all.indb EN-19 Instruction_honbun_all.indb EN-19 2011/04/18 17:54:37 2011/04/18 17:54:37