Panasonic TYWK103PV9 - Manual (Page 8)


WARNING
Ensure that the installation location is strong enough to support long-term use.
• If its strength becomes insufficient over the course of long-term use, the display may drop, possibly
causing injury.
Installation and removal should only be carried out by a qualified technician.
• If the bracket is installed incorrectly, the display may fall down and personal injury may result.
Make sure that all safety factors regarding strength of installation are observed.
• If the installation strength is insufficient, the display may fall down and personal injury may result.
Do not install in places which are unable to bear loads.
• If the strength of the installation surface is insufficient, the display may fall down and personal injury may
result.
CAUTION
Do not install in places which are subject to humidity, dust, oil fumes, water vapour or excessive
heat.
• These can have adverse effects on Plasma Display operation, and fire or electric shocks may result.
Do not use any displays other than those given in the catalogue.
• Otherwise the unit may be dropped and become damaged, and personal injury may result.
Do not install the Plasma Display face up, sideways or upside down.
• Doing so may cause heat to build up inside the display, and fire may result.
When installing or removing the plasma display, use a lowering device (machine), and ensure that
the work is done by at least four persons.
• If four people are not present, the display may be dropped, and personal injury may result.
Leave a space of at least 30 cm (11.8″) at the top, left and right, at least 15 cm (5.9″) at the bottom,
and at least 20 cm (7.9″) at the rear.
• The plasma display unit has air blow and air suction holes on the bottom and rear. Covering these may
result in a fire.
Requests regarding handling
1) Exercise care when selecting the location for the display because it may discolor or deform due to
light or heat if it is placed where it is exposed to direct sunlight, or near a heater.
) For cleaning, wipe the display using a soft dry cloth (made of cotton or flannel). If the unit is
extremely soiled, first wipe off soiling with a neutral detergent diluted in water, and then wipe with a
dry cloth. Do not use cleaners such as benzene, thinner or furniture wax because they may cause
paint peeling. (If using a chemical wiping cloth, follow any precautions included.)
) Do not affix adhesive tape or stickers to the product. Doing so may dirty the surface of the wall-
hanging bracket.
) Take care during installation as shocks can cause ‘panel cracks’ to the plasma dispaly unit.
Precautions with regard to setting up
PROFESSIONAL INSTALLATION IS REQUIRED.
PANASONIC DISCLAIMS ANY PROPERTY DAMAGE AND/OR SERIOUS INJURY, INCLUDING
DEATH RESULTING FROM IMPROPER INSTALLATION OR INCORRECT HANDLING.
English