Panasonic TY42TM4Z - Manual (Page 2)

2
Handle
Screws (x4)
Avoid riding on claws.
Slot
Terminal function label
(accessory)
1. Removing the Terminal Board from the
display:
1.
Remove the four screws that secure the Terminal
Board to the rear of the display.
2. Hold the Terminal Board by the side grips and
slowly pull it out in the direction of the arrow.
2. Installing the RGB (digital) Terminal Board:
1. Insert the RGB (digital) Terminal Board into the slot
until it is firmly plugged into the card connector.
• Check to make sure that the Board does not ride
on the two lower claws.
2. Secure the Board to the display with the four
screws removed in step 1 above. Tighten the
screws in the order of through .
3. Applying the terminal function label:
Peel off the backing sheet from the accessory
terminal function label and affix it over the existing
label.
• Make sure that the label is affixed with the correct
orientation.
Cover the work table with a soft, clean cloth and carefully place the display screen-panel down on the cloth.
Then follow the steps below.
• Before proceeding with the replacement steps, be sure to turn off the entire system including the
display, unplug all components from their outlets, and disconnect all the interconnect cables from
the display.
• When removing or installing the Board, exercise care not to scratch the display's rear panel surface
or labels.
Notes
Precautions:
• When removing or installing the Tuner Terminal Board, exercise care to avoid injury.
There may be some sharp-pointed solder joints on the rear side of the Board that could cause unexpected
injury.
• When installing the Board, note the following point:
Fully insert the Board into the slot horizontally until it is firmly plugged into the connector. Note that
incomplete insertion may damage the internal components.
Have the customer keep the removed Terminal Board for future servicing needs.
English