Panasonic TYWK5P1SW - Manual (Page 6)

6
English
4. Attaching the insulation spacers to the
display unit
1. Remove the top part of the outer cardboard box used for the plasma
TV unit, and pull the protective bag down.
To ensure that the plasma TV unit does not fall over, provide support at
the front.
2. Open the accessory pad.
Remove the installation stand, accessory box and speaker box from
the outer cardboard box.
Accessory pad
3. Remove the four caps from the display unit using a Phillips head
screwdriver.
Phillips head screwdriver
Cap
Cap
Note
• Keep the installation stand and also the caps which were removed in a safe
place.
4. Using the supplied Allen wrench , mount the 4 Allen head
countersunk screws , 4 dished toothed washers  and 4 insulation
spacers  provided at the locations where the caps were attached, as
shown in the figure on the right.
(Tightening torque: 3 to 4 N•m)
• If the insulation spacers  are not attached during the assembly process,
the display unit may be damaged as a result.




5. Connect the HDMI cable (either the one provided or one obtained
separately) to the display unit.
Use the HDMI cable in the length which is appropriate for the distance
from where the tuner unit is to be installed.
Notes
• For details on how to attach the speakers and other parts packed with
the plasma TV unit and to connect the HDMI cable, refer to the operating
instructions of the plasma TV unit.
• When a full Hi-Vision wireless unit is to be used, follow the instructions given in
the unit’s operating instructions.
Fitting procedure